ARP VG30DE (TT) Head & Main Stud Kit

ARP Head and Main Stud kit for the VG30DE(TT).  Recommended for engines producing 500+ rwhp.

Spend a few extra dollars on your engine for peace of mind knowing that it is secured with the best upgraded bolts on the market. 

This stud kit now comes complete with Z1 Custom Head Stud Washers!!

Head Stud Torque Spec's  : 90 ft-lbs w/moly lube on & under nut.  

Main Stud Torque Spec's : 70 ft-lbs w/moly lube on & under nut. 

Z1 recommends using the supplied ARP Moly Lube when torquing ARP fasteners.

Procedure for Installing Head Studs:  Finger tighten all the studs into the block once to make sure they fully seat. Make sure to put the 2 shorties in the correct places. Remove each and apply red loctite to the threaded ends going into the block and screw them back into place fully seated again. Install the heads. Install washers on all studs. Apply the ARP moly lube to each nut on the threads and bottom contact surface. The ARP lube is critcal because it sets the correct torque for the studs. Use of other lubricants will require other unknown torque values. Torque each to 90 ft-lbs in the pattern and manner noted in the factory service manual 3 times.