- OEM Parts
- Body (Front, Roof, Floor)
- Front Splashguards
Product Description
These undershrouds have been DISCONTINUED by Nissan and are no longer available!
Z1 offers an aluminum undershroud!!
This is the FRONT Undershroud found on ALL Z32s.
This undershroud is an important part for several reasons. It helps channel air coming in from the front grille into the AC condenser and radiator aiding in cooling. It ties together the lower portion of the front fascia, strengthening it and keeping its form. It helps keep road grime, debris, and trash out of the aftermarket air filters that most of us use and out of the AC condenser and radiator. We find that these are missing or damaged on many of the Z32's we service.
Fits:
- 1990-1996 Nissan 300ZX (Z32)
Note: The NA and TT versions have very minimal differences and can be used interchangeably.
 |
JDM 300ZX (Z32) Right Hand Drive (RHD) Cowl Panel Kit
starstarstarstarstar (5)
$146.94
300ZX (Z32) Hood / Support Repair Kit
starstarstarstarstar (2)
$84.99
99 JDM Bumper/Fascia lower lip foam insert & bracket
starstarstarstarstar_border (1)
$59
OEM 300ZX (Z32) Rear Hatch Moulding Clip
$3.93
Can these be used in conjunction with the JDM front fascia? My '95 N/A 300zx met with a chunk of truck tire and am in need of a new lower front end.
Unfortunately this will NOT work with a JDM fascia, however Z SPEED does make an undershroud that works with the JDM fascia at the link below.
(Link)OEM Fender Liner, Bumper, Body Trim Clip 09321
starstarstarstarstar_half (33)
$0.98
OEM 370Z Undershroud Bolt
starstarstarstarstar (3)
$0.98
OEM R35 GT-R Engine Undershroud Plug
starstarstarstarstar (1)
$0.97
OEM Front Fender Liner Screw - Upper
$1.48
OEM 370Z Undershroud Hardware Kit - Base
starstarstarstarstar (2)
$18.62
OEM R35 GTR Engine Undershroud Bolt
$0.91
starstarstarstarstar
Vyacheslav
November 12, 2022
All good no problem face shipping reliable customer service
starstarstarstarstar
Jeff
September 7, 2022
starstarstarstarstar
Samuel
April 29, 2021
This was a piece of equipment that was needed more than you know. Piece provided much needed protection for the undercarriage
starstarstarstarstar
Tim
December 9, 2020
Installed this NA oem shield on a 1993 300zx factory twin turbo. Fit was great. Fit around OEM intercooler piping with clearance to spare. Also the shield tucked up next to the horns and in between the plastic intercooler ducts with 1/4inch spacing in between. Thats the main difference from what I can see with the NA vs TT undershroud shield. I have comparison pictures and the only thing that is changed from what I can see is that. Part is flexible which is nice if you need a little flex when installing facia.
ASRIUBNFAIURNFKAJSNFLAKJSDNFLKASNDFLKASDNMFALKSNDFOANEF