- OEM Parts
- Powertrain
- Trans Case & Clutch Release
Product Description
This is the OEM pivot ball found on all '90 - 96 Z32's & 2003 Model 350Z's or G35's equipped with a manual transmission.
Sold individually.
Fits:
- 1990-1996 Nissan 300ZX (Z32)
- 2003-2008 Nissan 350Z (Z33)
- 2003-2006 Nissan G35 Sedan (V35)
- 2003-2007 Nissan G35 Coupe (V35)
 |
Nissan / Infiniti Manual Transmission Pilot Bushing
starstarstarstarstar (5)
$4.19
OEM 300ZX (Z32) Hair Pin Clutch Release Fork
$3.04
OEM Clutch Slave Cylinder VQ35DE
starstarstarstarstar (21)
$56.24
OEM VQ Manual Transmission Flywheel Bolt
starstarstarstarstar (10)
$3.53
OEM 300ZX (Z32) Clutch Release Fork Wire Clip
$5.84
OEM Clutch Pressure Plate Bolt
starstarstarstarstar (1)
$1.17
Upgraded Clutch Release Fork Assembly Kit
starstarstarstarstar (18)
$60.99
OEM Shifter Ball Socket Cup
starstarstarstarstar (21)
$41.99
OEM 350Z / G35 Clutch Throw Out Bearing
starstarstarstarstar (2)
$36.48
OEM Clutch Throw Out Bearing Sleeve
starstarstarstarstar (6)
$57.94
OEM Clutch Throw Out Bearing Retainer Spring (Cast Fork)
starstarstarstarstar (2)
$5.84
OEM 300ZX (Z32) Manual Transmission Rear Output Shaft Seal (5 Speed)
starstarstarstarstar_half (3)
$13.55
starstarstarstarstar
Juan
October 1, 2023
When I was replacing the clutch I noticed that this had broken away from the transmission housing and was still held in place via the metal clip and therefore still allowed it to pivot as its supposed to. After I extracted the broken stud replaced it with this part which is still running good almost 10 years later and about 40k miles. I had a rattle indication that would start when the car was in neutral and in gear with the clutch in. With a load or the clutch out the rattle would stop. After replacement the rattle went away and has stayed away. Now 140K 2003 G35 Coupe 6 Spd.
ASRIUBNFAIURNFKAJSNFLAKJSDNFLKASNDFLKASDNMFALKSNDFOANEF