The technological advancement of performance engines and even more so from tuned engines will increase the burden of stress on the head gasket. Under extreme conditions of high cylinder pressures and competition use, the head gasket is often the weakest point. The expansion and 3D pressure image shown, displays the effectiveness of the TOMEI multiple layered head gasket with the super grommet design (shown with the pressure image analysis system). The sealing performance is pursued with cross-section measurements and utilizing various functions within the design.

The gas sealing characteristics will improve with the raised rib, but the sealing characteristics of the neighboring water and oil channels are equally reduced. Therefore when pushing for power gains, these areas are weak points that can allow leakages. The TOMEI design focuses on all areas to provide the maximum seal with the use of the super grommet design. By using the rib height to ensure an equal overall high surface pressure seal, where it's needed the most.

• Fits SR20DET
• 88mm Bore Size
• Available in 1.2mm,1.5mm and 1.8mm gasket thickness.

We have decided to make various sizes available to suit each end users needs. The more options available will allow you to fine tune your engine to suit your specific needs to get that right compression ratio that you are after. Tomei compression ratio calculator can be found HERE.