ARP studs are recommended for VG30DE(TT) engines trying to achieve 500rwhp +.
Spend a few extra dollars on your engine for peace of mind knowing that it is secured with the best upgraded bolts on the market.
Main Stud Torque Spec's : 80 ft-lbs w/moly lube on & under nut.
Z1 recommends using the supplied ARP Moly Lube when torquing ARP fasteners.
Procedure for Installing Main Studs:
Finger tighten all the studs into the block once to make sure they fully seat. Remove each and apply red loctite to the threaded ends going into the block and screw them back into place fully seated again. Install the cradle. Install washers on all studs. Apply the ARP moly lube to each nut on the threads and bottom contact surface. The ARP lube is critical because it sets the correct torque for the studs. Use of other lubricants will require other unknown torque values. Torque each to 80 ft-lbs in the pattern and manner noted in the factory service manual 3 times.
Kit includes:
- (8) main studs, washers, and nuts
- (1) pack of ARP moly lube
|
 |