OEM Axle Nut Cotter Pin for a multitude of Nissan / Infiniti vehicles covered within the Z1 Motorsports catalog.
The axles on your Infiniti / Nissan are held in place by a single axle nut per side. This nut is torqued to the hub and allows the motor to transfer its power to the rear wheels without risk of the axle slipping from the hub under load. In front of this nut is a single cotter pin, put in place to keep the axle nut in place in the event that it slips.
This cotter pin should be replaced any time the axle is serviced. Fits both front and rear axles.
Sold Individually.
Fits:
- 2003-2008 Nissan 350Z (VQ35DE/HR)
- 2009-2016 Nissan 370Z (VQ37VHR)
- 2003-2008 Infiniti FX35 (VQ35DE)
- 2003-2008 Infiniti G35 (VQ35DE/HR)
- 2008-2013 Infiniti G37 (VQ35HR/VQ37VHR)
- 2011+ Nissan Juke (MR16DDT)
- 2014+ Infiniti Q50 (VQ35HR/VQ37VHR/VR30DDTT)
- 2017+ Infiniti Q60 Coupe (VR30DDTT)
- 2003-2008 Infiniti FX35 (VQ35DE)
- 2003-2008 Infiniti FX45 (VK45DE)
- 2004-2015 Nissan Titan (VK56DE)
- 2013-2019 Nissan Sentra (MRA8DE/MR16DDT)
- 2013-2018 Nissan Altima (QR25DE/VQ35DE)
Torque specifications and information regarding axle repair/replacement can be found below. Please note that the following information is specific to the 350Z. See your vehicles factory service manual for vehicle specific information.
Nissan TSB NTB04-065b - 350Z Axle Grease Procedure
|
 |