If you're looking to change the performance of your Z or G and improve acceleration through means other than horsepower, a final drive gear is the easiest way to achieve your goal!
By far the most noticeable increase in acceleration and response comes from simply re-gearing the differential in your car. By changing the input and output ratio on the ring and pinion, the car is able reach higher speeds in each gear. The Z1 3.69 Final Drive is a drop-in replacement for the factory ring and pinion, is compatible with all rear-wheel drive manual transmission differentials, and is available at a fraction of the cost of OEM gear sets.
Replacement bearings are required to install a new final drive in your differential. Through the product options, you can select to purchase all the required bearings and seals needed to re-gear your differential.
Included in the Bearing and Seal Kit:
- 2 X Nissan OEM Differential Side Carrier Bearings
- 2 X Nissan OEM Differential Side Oil Seals
- 1 X Nissan OEM Inner "Back" Pinion Gear Bearing
- 1 X Nissan OEM Pinion Crush Sleeve
- 1 X Nissan OEM Outer "Front" Pinion Gear Bearing
- 1 X Nissan OEM Pinion Oil Seal
- 1 X Permatex Ultra Gray Gasket Maker
It is highly recommended that an experienced mechanic install this ring and pinion gear set as excessive noise or even catastrophic failure can result from improper installation.
Fits:
- 2003-2008 Nissan 350Z
- 2003-2008 Infiniti G35
- 2008-2013 Infiniti G37
- 2009+ Nissan 370Z
ONLY compatible with MANUAL differentials!
*** This item does not qualify for any additional discounts or promotions *** |
 |